Specifications, 2006 Hatteras 50 Convertible...
Here is a brief overview. Click the "Downloads" tab above to obtain more detailed information. You might also want to visit the Hatteras website.
Equipment and Option Highlights, 2006 Hatteras 50 Convertible...
Optional Equipment
Wire for later installation of Windlass; DC electric bow thruster 12 12HP;
Prop removal/installation tool; Water delivery kit; Wash down freshwater
fore deck
Simpson Lawrence Windlass
Custom Equipment
Shore water connection at bow for dockside water
Wiring & selector panel for installation of shore power inlet 50 amp
Washer/dryer
Exterior Finish/Construction
Isopthalic gelcoat, interior layer, black
Isopthalic gelcoat, exterior layer, white
Blister resistant vinylester resin in hull bottom skin coat
Hull and superstructure, polyurethane coating
Polymer/copper based anti-fouling bottom paint
Boot stripe, polyurethane coating
Decks, non-skid surface, polyurethane paint with polymeric beads
Solid fiberglass hull bottom
Hull sides and superstructure laminated with Divinycell core
Fiberglass stringers
Steel laminated in stringers at key locations to bolt engine mounts
Engine room bulkheads and decks of resin-infused composite construction using PVC foam core with layers of fiberglass laminate on each side
Hardware and Miscellaneous
All hardware chrome on brass or welded and polished 316L stainless-steel
Fiberglass pulpit with welded and polished 316L stainless-steel anchor chute and roller
35-pound Danforth anchor, anchor line and deck hawse pipe with anchor tensioner
Polished 316L stainless-steel anchor cleat, through-bolted in aluminum backing plate
Two polished 316L stainless-steel stern cleats and hawse pipes, through-bolted in aluminum backing plate
Four polished 316L stainless-steel springline cleats with chafing strips, through-bolted in aluminum backing plate
Polished 316L stainless-steel bow cleats and chocks with chafing strips, drilled and tapped in aluminum backing plate
Brushed anodized welded aluminum rails on bow (with integrated pennant staff), sidedeck and flybridge, drilled and tapped in aluminum backing plates
Powder-coated grab rails on cabinside and flybridge interior
Brushed anodized welded aluminum flybridge ladder with acrylic steps
Fog bell
Zincs on rudders and shafts
Dual air/electric horn
Life ring
Life jackets (6)
Black braided nylon mooring lines (6)
Portable "drychem" and fire extinguishers (4), U.L. approved type in compliance with United States Coast Guard and ABYC standards
316L stainless-steel trim tabs
Integral manganese bronze struts
316L/Alloy 22 high-strength rudders
7-blade propellers, Nibral high performance
Alloy 22 high-strength propeller shafts, 3"
Manganese bronze dripless shaft and rudder seals with thrust bearing on rudder shaft
Central vacuum system
Black fenders (3)
316L stainless-steel reboarding steps to cockpit
Deck plates for fuel and water fills and waste pump out
Engine exhaust exits through transom; generator exhaust exits through hullside
